Issues a request to reboot to a remote node.

    Rather than specify the format to send MOP Version 3 or 4, the
    LANCP utility sends one message in each format to the target
    node.

    Format

      TRIGGER NODE node-specification

1  –  Parameter

 node-specification

    Supplies either the node name or the node address of the target
    node. If you supply the node name, the node address is obtained
    by looking up the node name in the LAN volatile node database. If
    you supply the node address, the corresponding node need not be
    defined in the LAN volatile node database. The address consists
    of 6 hexadecimal byte characters separated by hyphens or colons.

2  –  Qualifiers

2.1    /DEVICE

    /DEVICE=device-name

    Specifies the LAN device name to be used for sending the trigger boot
    messages. The device name has the form ddcu, where dd is the device
    identifier, c is the controller designation, and u is the unit number.

    LAN devices are specified as the name of the template device, which is
    unit 0. For example, the first EI Ethernet device is specified as EIA0,
    the second as EIB0, and so on. You can specify the first EI device, for
    example, as EIA, EIA0, or EIA0:.

2.2    /PASSWORD

    /PASSWORD=16hexdigits

    Supplies the password to be used when the connection is initiated,
    in hexadecimal (for example, /PASSWORD=0123456789ABCDEF). The default
    password is zero. You can omit leading zeros.

3  –  Examples

    1 LANCP> TRIGGER NODE GALAXY/DEVICE=EWA0

      This command sends MOP trigger boot messages to node GALAXY
      using Ethernet device EWA0.

    2 LANCP> TRIGGER NODE 08:00:2B:11:22:33/DEVICE=EWA0/PASSWORD=0123456789AB

      This command sends MOP trigger boot messages to the specified node
      address using the Ethernet device EWA0.