Library /sys$common/syshlp/DTSDTR.HLB  —  DATA  GENERAL QUALIFIERS

1    /NODENAME

       /NODENAME=node-id

    Identifies the node (by name or address) on which DTR is to run. The
    default is the local node. DTR runs on the default nonprivileged
    account on the remote node because access control information cannot
    be used as part of the node name. To run DTR on an account other
    than the default, you must create a new account and associate it
    with the DTR object.

2    /PRINT

       /PRINT
       /NOPRINT (D)

    Instructs DTS to print or log test results. The default is /NOPRINT.

3    /STATISTICS

       /STATISTICS (D)
       /NOSTATISTICS

    Instructs DTS to print statistics on data and interrupt tests. The
    default is /STATISTICS.

4    /DISPLAY

       /DISPLAY=number
       /NODISPLAY (D)

    Instructs DTS to print the specified number of bytes (in hexadecimal)
    of data and interrupt messages transmitted to DTR.  The default is
    /NODISPLAY.

5    /SPEED

 	/SPEED=number

    Indicates the line speed (in Mbps) of the test line. DTS uses
    this qualifier for reporting statistics (DTS does not control line
    speeds). The default number is 100(100 Mbps).

    The allowable values are 10 , 100 , 1000 and 10000 for 10 Mbps , 100 Mbps,
    1 Gbps and 10 Gbps respectively.
Close Help